lxc-start runs the specified
command inside the container
specified by name.
It will setup the container
according to the configuration previously defined with the
lxc-create command or with the configuration file parameter.
If no configuration is
defined, the default isolation is used.
The orphan process group
and daemon are not supported by this command, use
the lxc-execute command instead.
If no command is specified, lxc-start will
use the default
"/sbin/init" command to run a system
Run the container as a daemon. As the container has no
more tty, if an error occurs nothing will be displayed,
the log file can be used to check the error.
-f, --rcfile config_file
Specify the configuration file to configure the virtualization
and isolation functionalities for the container.
This configuration file if present will be used even if there is
already a configuration file present in the previously created
container (via lxc-create).
-c, --console console_file
Specify a file to output the container console. If the
option is not specified the output will go the terminal
except if the -d is specified.
-s, --define KEY=VAL
Assign value VAL to configuration
variable KEY. This overrides any
assignment done in config_file.
These options are common to most of lxc commands.
-?, -h, --help
Print a longer usage message than normal.
Give the usage message
Output to an alternate log
FILE. The default is no log.
Set log priority to
LEVEL. The default log
priority is ERROR. Possible values are :
Note that this option is setting the priority of the events
log in the alternate log file. It do not have effect on the
ERROR events log on stderr.
Use container identifier NAME.
The container identifier format is an alphanumeric string.
The container is busy
The specified container is already running an
application. You should stop it before reuse this
container or create a new one.