is a utility that allows you to authenticate to a MUPDATE server
and interactively issue commands to it. Once authenticated you may
issue any MUPDATE command by simply typing it in. It is capable
of multiple SASL authentication mechanisms and handles encryption
layers transparently. This utility is often used for testing the
operation of a mupdate server. Note that you must be an admin in order
to authenticate to an mupdate server.
Port to connect to. If left off this defaults to mupdate as defined
Force mupdatetest to use mechanism for authentication. If not specified
the strongest authentication mechanism supported by the server is
Userid to use for authentication; defaults to the current user.
This is the userid whose password or credentials will be presented to
the server for verification.
Userid to use for authorization; defaults to the current user.
This is the userid whose identity will be assumed after authentication.
NOTE: This is only used with SASL mechanisms that allow proxying
(e.g. PLAIN, DIGEST-MD5).
Minimum protection layer required.
Maximum protection layer to use (0=none; 1=integrity;
etc). For example if you are using the KERBEROS_V4 authentication
mechanism specifying 0 will force mupdatetest to not use any layer
and specifying 1 will force it to use the integrity layer. By
default the maximum supported protection layer will be used.
Specify the realm to use. Certain authentication mechanisms
(e.g. DIGEST-MD5) may require one to specify the realm.
Pipe file into connection after authentication.
Number of authentication attempts; default = 1. The client will
attempt to fast reauth (e.g. DIGEST-MD5), if possible.
Enable challenge prompt callbacks. This will cause the OTP mechanism
to ask for the the one-time password instead of the secret pass-phrase
(library generates the correct response).
Don't send an initial client response for SASL mechanisms, even if the
protocol supports it.