-h print help message -i access XPA point on different machine (override XPA_NSINET) -m override XPA_METHOD environment variable -n don't wait for the status message after server completes -p don't read (or send) buf data from stdin -s enter server mode -t [s,l] set short and long timeouts (override XPA_[SHORT,LONG]_TIMEOUT) -u [users] XPA points can be from specified users (override XPA_NSUSERS) -v verify message to stdout
Normally, xpaset reads data input from stdin until EOF and sends those data to the XPA target, along with parameters entered on the command line. For example to send a FITS file to the ds9 image display:
cat foo.fits | xpaset ds9 fits
Sometimes, however, it is desirable to send only parameters to an XPA access point, without sending data. For such cases, use the -p switch to indicate that there is no data being send to stdin. For example, to change the colormap used by the ds9 image display program, use:
csh> xpaset -p ds9 cmap Heat
Of course, this also can be accomplished by sending EOF to stdin in any of the usual ways:
csh> echo "" | xpaset ds9 cmap Heat csh> xpaget ds9 cmap Heat < /dev/null csh> xpaset ds9 cmap Heat ^D # Ctl-D signals EOF
The -s switch puts xpaset into server mode, in which commands and data can be sent to access points without having to run xpaset multiple times. (Its not clear if this buys you much!) The syntax for sending commands in server mode is:
csh> xpaset -s xpaset ds9 colormap I8 ^D xpaset ds9 regions circle 200 300 40 circle 300 400 50 ^D etc.
After the required ``xpaset'' command is specified, optional ASCII data can be appended (as in the region example). A single data/command set is delimited by ^D. Note that typing ^D when a command is expected terminates the program.
NB: server mode only works from the terminal and only ASCII data can be sent in this way.
csh> xpaset ds9 file < foo.fits csh> echo "stop" | xpaset myhost:12345