reads uses a list of files to prepare news batches for the specified
It is normally invoked by a script run out of
to lock the host name, followed by a
command to flush the batchfile.
reads the named
file, or standard input if no file is given.
Relative pathnames are interpreted from the
The input is taken as a set of lines.
Blank lines and lines starting with a number sign (``#'') are ignored.
All other lines should consist of one or two fields separated by a single space.
The first field is the name of a file holding an article; if it is not an
an absolute pathname it is taken relative to the news spool directory,
The second field, if present, specifies the size of the article in bytes.
The ``-S'' flag may be used to specify an alternate spool directory to
use if the article is not found; this would normally be an NFS-mounted
spool directory of a master server with longer expiration times.
By default, the program sets its standard error to
To suppress this redirection, use the ``-r'' flag.
reports statistics via
If the ``-v'' flag is used, they will also be printed on the standard
collects the text of the named articles into batches.
To limit the size of each batch, use the ``-b'' flag.
The default size is 60 kilobytes.
Using ``-b0'' allows unlimited batch sizes.
To limit the number of articles in each batch, use the ``-a'' flag.
The default is no limit.
A new batch will be started when either the byte count or number of
articles written exceeds the specified limits.
To limit the total number of bytes written for all batches, use the ``-B''
To limit the total number of articles that can be batched use the ``-A''
To limit the total number of batches that should be created use the ``-N''
In all three cases, the default is zero, which is taken to mean no limit.
A batch starts with an identifying line to specify the unpacking method
to be used on the receiving end.
When the ``-i'' flag is used, the initial string,
followed by a newline, will be output at the start of every batch.
The default is to have no initial string.
Each article starts with a separator line to indicate the size of the article.
To specify the separator use the ``-s'' flag.
This is a
format string which can have a single ``%ld'' parameter which will be given
the size of the article.
If the separator is not empty, then the string and a newline will be output
before every article.
The default separator is ``#! rnews %ld''.
By default, batches are written to standard output, which
is not useful when more than one output batch is created.
Use the ``-p'' flag to specify the shell command that should be
whenever a new batch is started.
The process is a
format string which can have a single ``%s'' parameter which will be given
the host name.
A common value is:
If the input is exhausted,
will exit with a zero status.
If any of the limits specified with the ``-B,'' ``-A,'' or ``-N'' flags
is reached, or if there is an error writing the batch, then
will try to spool the input, copying it to a file.
If there was no input filename, the standard input will be copied to
and the program will exit.
If an input filename was given, a temporary file named
is an absolute pathname)
(if the filename does not begin with a slash) is created.
Once the input is copied,
will try to rename this temporary file to be the name of the input file,
and then exit.
Upon receipt of an interrupt or termination signal,
will finish sending the current article, close the batch, and then
rewrite the batchfile according as described in the previous paragraph.
Written by Rich $alz <firstname.lastname@example.org> for InterNetNews.
This is revision 1.18, dated 1996/10/29.