loads the FPGA firmware to the Xorcom Astribank device.
The syntax resembles that of fxload(8).
Before writing firmware, bump the processed binary file to
Required. The device to read from/write to. On modern UDEV-based system
this is usually /dev/bus/usb/bus_num/device_num,
where bus_num and device_num are the first two numbers in the
output of lsusb(8).
On older systems that use usbfs, it is usually
Reset the Astribank and renumerate its USB connection to power on product ID.
Dump all eeprom data to standard output.
The firmware file to write to the device.
Show information about the firmware file (valid only with -I option).
./FPGA_1151.hex: Version=3297 Checksum=58270
In particular, the calculated checksum should match the output of sum(1)
on the binary firmware file generated by the -b option.
This manual page was written by Tzafrir Cohen <firstname.lastname@example.org> .
Permission is granted to copy, distribute and/or modify this document under
the terms of the GNU General Public License, Version 2 any
later version published by the Free Software Foundation.
On Debian systems, the complete text of the GNU General Public
License can be found in /usr/share/common-licenses/GPL.