Section: Maintenance Commands (8)Updated: November 2006Local indexUp
mpt-status - retrieve configuration and health status from LSI hardware RAID controllers
mpt-status [ options ]
The mpt-status software is a query tool to access the running
configuration and status of LSI SCSI HBAs. mpt-status allows you to
monitor the health and status of your RAID setup.
This will try to automatically load the mptctl kernel module.
-u --controller <int>
Set the IOC unit (controller).
Print some help information.
Use the new style output. This parameter was introduced to retain
backwards compatibility. If not set, you get the old style output.
It is very likely that the output of the newstyle format will change
heavily in the future, so do not rely on it when writing plugins for
monitoring software, for example.
-i --set_id <int>
Set id of primary device (check README).
Use this to probe SCSI id's when not on id 0.
Do not display any warnings.
Only print the status information. This can
be used for easy scripting
Print verbose information, such as warnings
Print version information
-d --debug [<int>]
Enable debugging and set level optionally.
NOTE: This is not fully implemented yet.
The program's exit(2) status is meant to be interpreted as a bit
mask. If everything went well, zero is returned. If not (i.e. if
for example an error or unknown condition is detected), the bits
of the return value shall be interpreted as:
A logical volume has failed
A logical volume is degraded
A logical volume is resyncing
At least one physical disk failed
At least one physical disk is in warning condition
Report bugs to your linux distribution or software vendor, if mpt-status
was bundled on your installation. If you have been compiling mpt-status
from the vanilla sources and experience problems, redirect them to
preferably <email@example.com> or <firstname.lastname@example.org>.
Besides design bugs, gross software engineering and missing features,
this software is considered pretty stable and can be used in production