Section: Maintenance Commands (8) Updated: February 18, 2002 Local index
myson-diag - EEPROM setup and diagnostic program for ethernet cards based on the Myson MTD803 chip.
myson-diag is a program that you can use to diagnose problems with ethernet cards
based on the Myson MTD803 chip.
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (`-').
A summary of options is included below.
Show summary of options.
Show version of program.
Be very unverbose.
Use card number <cardnum>.
Print all registers.
Dump EEPROM contents to stdout.
Re-write a corrupted EEPROM.
-p, --port-base <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx,
100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx,
10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX,
MII and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
Dump MII management registers.
Reset the transceiver.
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run myson-diag with the options '-t -1'.
myson-diag was written and is still maintained by Donald Becker
This manual page was written by Alain Schroeder < email@example.com>,
for the Debian GNU/Linux system (but may be used by others).
This document was created by
using the manual pages.
Time: 22:02:01 GMT, April 16, 2011