Poster of Linux kernelThe best gift for a Linux geek
NATSEMI-DIAG

NATSEMI-DIAG

Section: Maintenance Commands (8) Updated: February 18, 2002
Local index Up
 

NAME

natsemi-diag - EEPROM setup and diagnostic program for ethernet cards based on the National Semiconductor DP83810 / 83815 chips.  

SYNOPSIS

natsemi-diag [options]  

DESCRIPTION

netsemi-diag is a program that you can use to diagnose problems with ethernet cards based on the National Semiconductor DP83810 / 83815 chips.  

OPTIONS

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
-h, --help
Show summary of options.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-q, --quiet
Be very unverbose.
-a, --show_all_registers
Print all registers.
-# <cardnum>
Use card number <cardnum>.
-e, --show-eeprom
Dump EEPROM contents to stdout.
-E, --emergency-rewrite
Re-write a corrupted EEPROM.
-p, --port-base <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
-m, --show-mii
Dump MII management registers.
-R, --reset
Reset the transceiver.
-T, --test
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!
-f, --force-detection
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run natsemi-diag with the options '-t -1'.
 

SEE ALSO

mii-diag(8)  

AUTHOR

netsemi-diag was written and is still maintained by Donald Becker <becker@scyld.com>. This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).


 

Index

NAME
SYNOPSIS
DESCRIPTION
OPTIONS
SEE ALSO
AUTHOR

This document was created by man2html, using the manual pages.
Time: 22:02:02 GMT, April 16, 2011