Poster of Linux kernelThe best gift for a Linux geek
ONEAC

ONEAC

Section: NUT Manual (8) Updated: 12/24/2010
Local index Up
 

NAME

oneac - Driver for Oneac UPS equipment  

NOTE

This man page only documents the hardware-specific features of the oneac driver. For information about the core driver, see nutupsdrv(8).  

SUPPORTED HARDWARE

This driver supports Oneac EG and ON UPS equipment with the Advanced Interface. If your UPS is equipped with the Basic Interface card, use the genericups driver.  

EXTRA ARGUMENTS

This driver supports the following optional settings in the ups.conf(5) file:

testtime=num

Change battery test time from the 2 minute default.
 

INSTANT COMMANDS

This driver supports the following Instant Commands.

reset.input.minmax

Reset the minimum and maximum input line voltage values seen since the last reset or power on.

test.battery.start

Start a battery test. The default time is 2 minutes. This time can be set in the ups.conf file. See testime above.

test.battery.stop

Stops a battery test that is in progress.

test.failure.start

Starts a 15 second long simulation of an input power failure.
 

AUTHOR

Eric Lawson <elawson@inficad.com>  

SEE ALSO

 

The core driver:

nutupsdrv(8)  

Internet resources:

The NUT (Network UPS Tools) home page: http://www.networkupstools.org/


 

Index

NAME
NOTE
SUPPORTED HARDWARE
EXTRA ARGUMENTS
INSTANT COMMANDS
AUTHOR
SEE ALSO
The core driver:
Internet resources:

This document was created by man2html, using the manual pages.
Time: 22:02:05 GMT, April 16, 2011