Poster of Linux kernelThe best gift for a Linux geek
PCI-CONFIG

PCI-CONFIG

Section: Maintenance Commands (8) Updated: February 18, 2002
Local index Up
 

NAME

pcnet-diag - EEPROM setup and diagnostic program for ethernet cards based on the AMD PCnet/PCI series chips.  

SYNOPSIS

pci-config [options]  

DESCRIPTION

pci-config is a program that you can use to diagnose problems with ethernet cards  

OPTIONS

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-# <device-index>
Operate only on device <device-index>.
-a, --show_addresses
Show PCI registers
-S, --sleep
Put device to sleep (ACPI D3).
-W, --wake
Wake a sleeping device (ACPI D0 state).
-B, --bus <bus>
Show only devices on BUS.
-A, --set-addresses <addr>
Set PCI address register 1 to the <addr>.
-D, --debug
Show details of operations.
-f, --force
Override checks and perform the operation.
-u, --usage
Show a long usage message.
 

SEE ALSO

mii-diag(8)  

AUTHOR

pci-config was written and is still maintained by Donald Becker <becker@scyld.com>. This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).


 

Index

NAME
SYNOPSIS
DESCRIPTION
OPTIONS
SEE ALSO
AUTHOR

This document was created by man2html, using the manual pages.
Time: 22:02:07 GMT, April 16, 2011