Send a SCSI REPORT TARGET PORT GROUPS command to DEVICE and
outputs the response.
Target port group access is described in SPC-3 found at www.t10.org
in section 5.8 (in rev 21c dated 2005/1/15). The Report Target Port
Groups command is also described in that document.
OPTIONS
Arguments to long options are mandatory for short options as well.
-d, --decode
decodes the status code and asymmetric access state from each
target port group descriptor returned. The default action is not
to decode these values.
-h, --help
output the usage message then exit.
-H, --hex
output response in hex (rather than partially or fully decode it).
-r, --raw
output response in binary to stdout.
-v, --verbose
increase the level of verbosity, (i.e. debug output).
-V, --version
print the version string and then exit.
NOTES
The Report Target Port Groups command should be supported whenever the TPGS
bits in a standard INQUIRY response are greater than zero. [View with
sg_inq utility.]
EXIT STATUS
The exit status of sg_rtpg is 0 when it is successful. Otherwise see
the sg3_utils(8) man page.