Section: D-Bus services (8) Updated: October 2007 Local index
telepathy-haze - Telepathy connection manager using libpurple
Haze implements the Telepathy D-Bus specification using libpurple,
allowing Telepathy clients like
to connect to any protocol supported by
It is a D-Bus service which runs on the session bus, and should usually be
started automatically by D-Bus activation. However, it might be useful to
start it manually for debugging.
There are no command-line options.
May be set to "all" for full debug output, or various undocumented options
(which may change from release to release) to filter the output.
If set, Haze will not automatically close itself after five seconds without
If set, all debugging output will be written to filename rather than
to the terminal.
- SEE ALSO
This document was created by
using the manual pages.
Time: 22:02:29 GMT, April 16, 2011