Poster of Linux kernelThe best gift for a Linux geek
TRIPPLITE

TRIPPLITE

Section: NUT Manual (8) Updated: 12/24/2010
Local index Up
 

NAME

tripplite - Driver for Tripp-Lite SmartPro UPS equipment  

NOTE

This man page only documents the hardware-specific features of the tripplite driver. For information about the core driver, see nutupsdrv(8).  

SUPPORTED HARDWARE

This driver should work on the SmartPro line, including the SMART700 and SMART700SER. It only supports SmartPro models that communicate using the serial port.  

EXTRA ARGUMENTS

This driver supports the following optional settings in the ups.conf(5):

offdelay=num

Time to wait before the UPS is turned off after the kill power command is sent. The default value is 64 (in seconds).

rebootdelay=num

Set the timer before the UPS is cycled after the reboot command is sent. The default value is 64 (in seconds).

startdelay=num

Set the time that the UPS waits before it turns itself back on after a reboot command. The default value is 60 (in seconds).
 

KNOWN ISSUES AND BUGS

Battery charge information may not be correct for all UPSes. It is tuned to be correct for a SMART700SER. Other models may not provide correct information. Information from the manufacturer would be helpful.  

AUTHORS

Rickard E. (Rik) Faith, Nicholas Kain  

SEE ALSO

 

The core driver:

nutupsdrv(8)  

Other drivers for Tripp-Lite hardware:

tripplitesu(8), tripplite_usb(8), usbhid-ups(8)  

Internet resources:

The NUT (Network UPS Tools) home page: http://www.networkupstools.org/


 

Index

NAME
NOTE
SUPPORTED HARDWARE
EXTRA ARGUMENTS
KNOWN ISSUES AND BUGS
AUTHORS
SEE ALSO
The core driver:
Other drivers for Tripp-Lite hardware:
Internet resources:

This document was created by man2html, using the manual pages.
Time: 22:02:32 GMT, April 16, 2011