Section: Maintenance Commands (8)Updated: February 18, 2002Local indexUp
tulip-diag - EEPROM setup and diagnostic program for ethernet cards based
on the Digital DC21x4* chip.
tulip-diag is a program that you can use to diagnose problems with
ethernet cards based on Digital DC21x4* chips. This includes the following
chips: Digital and Intel 21040/041/140/142/143/145 and others from Lite-On,
LinkSys, Macronix, ASIX, Compex, STmicro, ADMtek, Davicom and Xircom.
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (`-').
A summary of options is included below.
Show summary of options.
Show version of program.
Be very unverbose.
Use card number <cardnum>.
Print all registers.
Dump EEPROM contents to stdout.
Re-write a corrupted EEPROM.
-p, --base-address <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx,
100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2, AUI,
100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX,
MII, HomePNA and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
Dump MII management registers.
Reset the transceiver.
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run tulip-diag with the options '-t -1'.
tulip-diag was written and is still maintained by Donald Becker
This manual page was written by Alain Schroeder <firstname.lastname@example.org>,
for the Debian GNU/Linux system (but may be used by others).