wackatrl
runs the wackatrl IP-failover HA controller and instructs the currently
running Wackamole instance to perform an action or display state information.
OPTIONS
-c config-file
Use an alternate configuration file
config-file
instead of
wackamole.conf.
-l
Lists the current state (ownership) of virtual interfaces.
-f
Simulate a failure. The local instance will disconnect from Spread and
act as if it has failed by dropping its managed interfaces and running
whatever dynamic calls have been configured. A peer, should one exist,
will assume the responsibility for the interfaces that were dropped.
-s
Recover from a simulated failure. This will tell the local instance to
stop simulating failure. The local instance will reconnect to Spread and
once again participate in the peer-based HA environment.
FILES
wackamole.conf
The default config file location is dependant on the install prefix.
./wackamole.conf
is also searched if a local file is not found.
DIAGNOSTICS
All error messages, should any be produced will be written to standard
error.